Count; Data - HP 16533A Programmer's Manual

COUNt?

Query :WAVeform:COUNt?
The COUNt query returns the count last specified in the ACQuire Subsystem.
Returned Format
[:WAVeform:COUNt] <count><NL>
{2|4|8|16|32|64|128|256}
<count>
Example
OUTPUT XXX;":WAVEFORM:COUNT?"

DATA?

Query :WAVeform:[SOURce CHANnel<N>;]DATA?
The DATA query returns the waveform record stored in a specified channel
buffer. The WAVeform:SOURce command is used to select the specified
channel. The data is transferred based on the FORMAT (BYTE, WORD or
ASCII) chosen and the RECORD specified (FULL or WINDOW). Since
WAVeform:DATA is a query, it cannot be used to send a waveform record
back to the scope from the controller. If a waveform record is saved for later
reloading into the oscilloscope, the SYSTem:DATA command should be used.
Returned Format
[:WAVeform:DATA]#800032768 <block data><NL>
1 through the number of channels in the oscilloscope connected as one unit
<N>
(maximum of 8 channels), otherwise the maximum number of channels is 2
Example
OUTPUT XXX;":WAVEFORM:DATA?"
An example using the DATA command can be found in Chapter 11,
Programming Examples.
WAVeform Subsystem
COUNt?
10–9