Minus; Overlay - HP 16533A Programmer's Manual

DISPlay Subsystem

MINus

MINus
Command :DISPlay:MINus [<module_number>,]<label>,<label>
The MINus command algebraically subtracts one channel from another and
inserts the resultant waveform to the display. Note that both channels must
in the same oscilloscope module. The first parameter is an optional module
specifier. The module is identified by the slot number that contains the
oscilloscope master card. If a module is not specified, the current module is
assumed. The next two parameters are the label of the waveform selected to
be added to the display. The label names are defined in the same manner as
the INSert command.
slot number in which oscilloscope master card is installed
<module_
number>
string of 1 alpha and 1 numeric character enclosed by single quotes
<label>
Example
OUTPUT XXX;":DISPLAY:MINUS 3,'C1','C2'"

OVERlay

Command :DISPlay:OVERlay <label>,<label>[,<label>...]
The OVERlay command overlays oscilloscope waveforms. The syntax
parameters are the labels of the waveforms that are to be overlaid. Only
waveforms sharing a common master card can be overlaid. A label may be
used only once with each OVERlay command.
<label>
string of 1 alpha and 1 numeric character enclosed by single quotes
Example
OUTPUT XXX;":DISPLAY:OVERLAY 'C1','C2'"
or
OUTPUT XXX;":DISPLAY:OVERLAY 'C1','C2','B1','B2'"
5–8