Table of Contents
Advertisement
Programming the
HP 16533/34A Oscilloscope Module
Mainframe Commands
The STOP command stops the selected module or intermodule. If the
selected module is configured for intermodule, STOP will stop all modules
configured for intermodule.
RMODe
The RMODe command specifies the run mode (either single or repetitive) for
a module or intermodule. If the selected module is configured for
intermodule, the intermodule run mode will be set by this command.
RMODe?
The RMODe query returns the current setting.
SYSTem:ERRor?
The SYSTem:ERRor query returns the oldest error in the error queue. In
order to return all the errors in the error queue, a simple FOR/NEXT loop can
be written to query the queue until all errors are returned. Once all errors
are returned, the queue will return zeros.
SYSTem:PRINt
The SYSTem:PRINt command initiates a print of the screen or listing buffer
over the current printer communication interface.
SYSTem:PRINt?
The SYSTem:PRINt query sends the screen or listing buffer data over the
current controller communication interface.
MMEMory Subsystem
The MMEMory Subsystem commands provide access to both internal disc
drives for loading and storing configurations.
INTermodule Subsystem
The INTermodule Subsystem commands are used to specify intermodule
arming between multiple modules.
1–7
Advertisement
Table of Contents
