Plus; Remove - HP 16533A Programmer's Manual

PLUS

Command :DISPlay:PLUS [<module_number>,]<label>,<label>
The PLUS command algebraically adds two channels and inserts the
resultant waveform to the current display. Note that both channels must in
the same oscilloscope module. The first parameter is an optional module
specifier and needs to be used only if another module is displayed. The next
parameters are the labels of the waveform that are to be added.
slot number in which oscilloscope master card is installed
<module_
number>
string of 1 alpha and 1 numeric character enclosed by single quotes
<label>
Example
OUTPUT XXX;":DISPLAY:PLUS 2,'B1','B2'"

REMove

Command
:DISPlay:REMove
The REMove command removes all displayed waveforms from the current
display.
Example
OUTPUT XXX;":DISPLAY:REMOVE"
DISPlay Subsystem
PLUS
5–9