Table of Contents
Advertisement
Introduction
In addition to automatic parametric measurements, the oscilloscope
has four markers for making time and voltage measurement. These
measurements may be made automatically or manually. Additional
features include the centering of trigger or markers in the display area
(CENTer) and the run until time (RUNTil) mode. The RUNTil mode
allows you to set a stop condition based on the time interval between
the X marker and the O marker. When this condition is met, the
oscilloscope will stop acquiring data. Refer to Figure 6-1 for the
Marker Subsystem Syntax Diagram. The MARKer Subsystem
commands are:
AVOLt
ABVolt
BVOLt
CENTer
MSTats
OAUTo
OTIMe
RUNTil
SHOW
TAVerage
6–2
TMAXimum
TMINimum
TMODe
VMODe
VOTime
VXTime
VRUNs
XAUTo
XTIMe
XOTime
Advertisement
Table of Contents
