96
6. Instructions for Factory / Field Installation of High
Speed Verifier Assembly 580015
Installation Procedure - Mechanical
All manuals and user guides at all-guides.com
1) Disconnect Power to Printer.
2) Disconnect Stacker Cable & Remote Control Panel (if so equipped).
3) Remove the Rear Cover (save screws).
4) Install the base Verifier Mount Bracket on the back of the Upright Frame
in (2) 10-32 Pem Nuts directly above the Auxiliary Drive Gear. Use (2)
10-32 x 1.00 Cap Screws. Tighten Securely.
5) Install the Upper Verifier Mount Bracket onto Base Bracket with radius
corner toward the Unwind end of the Printer. Secure with assembled ¼-
20 x ¾ Cap Screw & Thumb Cap.
BASE VERIFIER MOUNT BRACKET
User's Manual—SNAP™ 500 Adidas Printer
1/4 THUMB CAP
1/4-20 X 3/4 CAP SCREW
UPPER VERIFIER MOUNT BRACKET
10-32 X 1 CAP SCREWS