Installing Ink To The Bottom Ink Supply Station; Loading The Tape - Avery Dennison SNAP 500 Adidas User Manual

User's Manual—SNAP™ 500 Adidas Printer

3.1.2 Installing Ink to the Bottom Ink Supply Station

3.1.3 Loading the Tape

All manuals and user guides at all-guides.com
Installing Ink on the Bottom Print Station is done in the same way as the Top
Print Station, except that the ink runs up over the Turnbar, across the printhead
to the rewind arbor.
Before loading a roll of tape, you will need to be familiar with the following parts
of the AVERY DENNISON SNAP 500 printer (Refer to Figures 9 and 10).
The Tape Arbor is designed to clamp the core of the tape supply rolls to hold
them in place during printing operations. By rotating the outer knob on the tape
arbor, you can adjust for roll widths ranging in size from ½ inch - 2 ¼ inches
(12.7 mm – 57.2 mm). This helps keep the tape straight while it moves to the
center of the print head. To function properly, the tape roll must be wound
firmly and centered on the core with no telescoping of the roll. You do not need
to make any other adjustments.
The Tape or Web Guide is located between the Tape Arbor and Lower Print
Station and guides the tape through the machine toward the print head. The
large black knob located above the web guide controls the width of the guides.
Turning the knob clockwise will widen the web guides, while counterclockwise
turns will narrow the web guides.
Special for the SNAP 500 Adidas machine is the Mini Web Guide Adapter. To
use, turn the large black web guide knob to widen the web guide plates to their
maximum "open" position. Slide the Mini Web Guide Adapter up, under the
web guide, in between the web guide plates. The Mini Web Guide Adapter will
"clip" onto the web guide posts. Turn the large black web guide knob so that the
web guide plates close in on the Mini Web Guide Adapter. Doing this will
automatically center the Mini Web Guide Adapter.
WEB GUIDE POST
WEB GUIDE PLATE
MINI WEB GUIDE ADAPTER
WEB GUIDE POST
23