Printing The Test Labels - Avery Dennison SNAP 500 Adidas User Manual

User's Manual—SNAP™ 500 Adidas Printer
1. Press and hold the Voice button until the printer says "Press Start for Test
2. Press the Start button. The printer will say "Press Start for Test Pattern 1." If
3. The printer will say "Ready to print test pattern 1 (or 2), Returning to print

2.6.3 Printing the Test Labels

All manuals and user guides at all-guides.com
Patterns."
you want to print test pattern 1, press the Start Button, then go to step 3. If you
want to print test pattern 2, press the Voice button. The printer will say "Press
Start for Test Pattern 2." Press the Start button.
mode." At this time the Data light will come on. The printer is now ready to
print the test labels.
Press the Start button. The stacker (if installed) will move the platform to its start
position and the printer will begin printing the test labels.
If any problems occur, either the Supply or Error light will come on. If this
happens, press the Voice button and the printer will say a message telling what
the problem is. Correct the problem and press the Start button again. Repeat
this until the printer runs continuously.
If you can't get the printer to run, refer to sections 9 and 10 Troubleshooting.
19