Chapter 2 Disassembly Process; Equipment Needed & Product Overview - Barco CLM W6 Service Manual

2. Disassembly Process
2-1 Equipment Needed & Product Overview
. Screw Bit (+) :05
2. Screw Bit (+) :07
3. Screw Bit (-) :07
4. Hex Sleeves 5 mm
5. Tweezers
6. + NO.0 Screwdriver
7. Knife
8. Projector
* Caution:
-This process is protective level II. Operators should wear electrostatic chains.
-The unit should be powered down and disconnected from mains.
-When disassemble Engine module (2-18), please notice that it require specific
environmental conditions (clean room).
CLM W6_CLM HD6 Jan 3, 202

Chapter 2 Disassembly Process

2-