Volkswagen Golf 1999 Service Manual page 4824

General
Installing front valance spoiler
1. Cover
2. Screw (Qty. 2). Torque specification: 2 Nm
3. Speed nut (Qty. 2)
4. Front valance spoiler. (Clipped to cover)
Warning!
When first installing front valance spoiler additional
bolts must be installed on both sides.
Install additional bolts at front valance spoiler (Jetta
GLI)
Note:
Additional screws must be installed on both sides of vehicle
when first installing front valance spoiler. This prevents
damage to front valance spoiler.
Following illustrations show right hand wheel housing liner.
Mounting on left hand wheel housing ls similar
Mounting - 1 - shown in illustration has already been done
in factory.
Material required
Speed nut (Qty. 2)
Self tapping screws (Qty. 2)
Additional bolts (rear view)
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
Página 2 de 23
13/2/2005