SSANGYONG RODIUS 2005.07 Manual page 384

4. FUNCTIONS OF RAIN SENSOR
1) Windshield Glass and Coupler Attachment
Check the outer windshield surface of sensing area for wear, damage and scratch. The sensor
is able to compensate the wear up to a specific level. Check the coupler attached surface of
windshield for porosity. If the porosity exists, the sensor cannot function properly.
- If the installed wiper brushes are out of specification (size and length), the rain sensing
area cannot be fully wiped.
decreased and the wipers are not properly operated
2) Recognition of AUTO Mode
1) When the engine is started with the wiper switch "AUTO"
one cycle to remind a driver that the wiper switch is in "AUTO"
2) When the wiper switch is turned to "AUTO"
always operates one cycle for the initial operation, however, the wiper does not operate
afterwards to prevent the wiper blade wear if not raining when turning the wiper switch to
"AUTO" from "OFF". However, the wiper operates up to 5 minutes after rain stops.
3) If this function does not occur, check No. 2 terminal on the rain sensor. If any defective
cannot be found, check the wiper relay (LOW) for defective.
- As described, the STICS recognizes the wiper switch "AUTO"
any problem, go to diagnosis mode in STICS and check the terminal that receives signal
from wiper and communication lines between rain sensor unit and STICS.
3) Instant Wipe Function
When the variable resistance knob on the multifunction wiper switch is turned by each 1 stage
from low sensitivity (Smark) to high sensitivity (F mark), the wiper operates one cycle.
And, the wiper also operates during raining up to 5 minutes after rain stops.
In this case, the rain sensor's
from OFF, the wiper operates one cycle. It
8610-11
sensitivity could be
position, the wiper operates
position.
position. If there are not
RAIN SENSOR
RODIUS 2005.07
0-7