SSANGYONG RODIUS 2005.07 Manual page 351

0-38
8710-01
14) Theft Deterrent
(1) Description of Burglar Alarm Function
▶
Description of Burglar Alarm Function
The "LOCK" output is "ON" when receiving the "LOCK" signal from transmitter while
1.
the ignition key is removed and all doors are closed. The armed mode is activated when the
door lock switch is locked (theft deterrent horn output: once, hazard relay output: twice).
The theft deterrent horn and hazard relay outputs are "ON"
2.
signal from the remote control key again in armed mode (theft deterrent horn output: once,
hazard relay output: twice).
When receiving "LOCK" signal from the remote control key while any of doors is not
3.
closed, only the "LOCK" output can be done and then activates the armed ready mode
(without theft deterrent horn and hazard warning flasher). At this moment, if the ignition key
is in the ignition switch, the door unlock switch is turned "ON"
is unlocked (after 0.6 seconds), cancels the armed mode and activates the normal mode.
However, in these cases, if closing the door and locking the door lock switch, the theft
deterrent horn outputs once and the hazard warning flasher outputs twice and then activates
4. armed mode.
When the door is not opened or the ignition key is not inserted into ignition switch for 30
seconds after receiving "UNLOCK"
mode (RELOCK operation). Also, at this moment, the system outputs the theft deterrent
5. horn and hazard warning flasher.
The armed mode will not be activated except above conditions.
Ex) The armed mode will not be activated when the door is locked by the ignition key.
STICS
RODIUS 2005.07
signal, outputs "LOCK" and then activates armed
when receiving the "LOCK"
or the door lock switch