SSANGYONG RODIUS 2005.07 Manual page 382

2. RAIN SENSOR OPERATION
The rain sensor is installed on the specific heat treated windshield that has minimum 13% of
transmittance rate with specified intensity of radiation. It is installed on the glass with a
adhesive of Sorepa.
It communicates with STICS and makes the wipers to operate automatically under the rain
sensing mode (multifunction switch wiper: AUTO mode).
The emitting section of the rain sensor unit emits infrared rays against the windshield and then
detects the amount of rain drops by receiving reflected rays with photodiode.
The sensing section on the windshield is located just above the center point between LED and
photodiode.
Components and functions of the rain sensor unit
Rear
Front
Rain
sensor unit
Rain sensor unit (including cover)
Unit latch
Housing and PCB
PCB assembly and
emitter lens
Emitter lens
The LED emits the infrared
rays is located at bottom and
the lens guides the infrared
rays to target point.
Housing and
receiver lens
Receiver lens
The receiver lens guides the
reflected infrared rays from
windshield to photodiode.
0-5
8610-11
RAIN SENSOR
RODIUS 2005.07