SSANGYONG REXTON 2006.09 Manual page 497

05-16
8810-05
11) Wiring Harness Connectors
If the sensing and diagnostic module (SDM) electrical connector is not attached properly, a built
in shorting bar will connect the wire from airbag warning lamp with the SDM ground wire. This
turns on the AIRBAG indicator.
To prevent deployment during servicing, additional shorting bars are located in following
locations:
· Driver airbag module connector
Passenger airbag module connector
·
Driver and passenger side airbag module connector
·
· SDM wiring harness connector
Contact coil connector to airbag wiring harness
·
The shorting bar is only a backup safety device. Always disable the supplemental restraints
system (SRS) before beginning any service procedure.
12) Belt Pretensioner
The belt pretensioner enables to retract the driver and the passenger seat belt webbing to
reduce any personal impact when accounted a frontal collision.
AIR BAG AND SEAT BELT
REXTON 2006.09