Table of Contents
Advertisement
17-18
4892-01
1.
Disconnect the EBCM harness connector before performing the electric welding
procedures.
2.
Carefully note the routing of the ABS/TCS wiring and wring components during removal.
The ABS/TCS components are extremely sensitive to EMI (eletromagnetic interference).
Proper mounting is critical during component service.
3.
Disconnect the EBCM connector with the ignition OFF.
4.
Do not hang the suspension components from the wheel speed sensor cables. The cables
may be damaged.
5.
Do not use petroleum based fluids in the master cylinder. Do not use any containers
previously used for petroleum based fluids. Petroleum causes swelling and distortion of the
rubber components in the hydraulic brake system, resulting in water entering the system
and lowering the fluid boiling point.
ANTI-BRAKE SYSTEM
REXTON 2006.09
Hide quick links:
Advertisement
Chapters
Table of Contents
