SSANGYONG REXTON 2006.09 Manual page 488

13. Touch one wire to the positive battery terminal and touch the other wire to the negative
battery terminal.
The airbag module will deploy.
14. Refer to "DEPLOYED AIRBAG MODULE DISPOSAL PROCEDURE" in this section.
▶ Airbag module discard (passenger)
The passenger airbag deployment is the same procedure of the driver's. Remove the glove box
instead of the contact coil and cut two passenger airbag wires.
Refer to "AIRBAG MODULE DISCARD (DRIVER)" in this section for more information.
▶ Airbag module deployment (outside vehicle)
Deploy airbag modules in following situations:
If the airbag module is removed in the discarded vehicle.
·
If the airbag module is replaced due to any fault.
·
If an airbag module is damaged during transfer, storage or servicing.
·
Observe following precaution if the airbag is deployed:
Deploy the airbags only in an evacuated area. Service mechanics should be at least 10
·
meters (33 feet).
· Do not connect the voltage source until after having completed all other preparations for the
deployment of the airbags.
Allow a deployed airbag module or pretensioner to cool for at least 30 minutes before
·
handling.
If the deployment fails, disconnect the voltage source and wait 5 minutes before
·
approaching the vehicle.
1. Position the airbag module face up, on flat ground outdoors, at least 10 meters (33 feet)
from any obstacle or people.
2. Place a vehicle battery at least 10 meters (33 feet) away from the airbag module.
3. Deploy the airbag module using the deployment tool. If you do not have deployment tool, cut
the two additional wires to the airbag module and strip 13 mm (0.5 inch) of the insulation
from the end of the wires leading to the airbag module.
4. Refer to "DEPLOYED AIRBAG MODULE DISPOSAL PROCEDURE" in this section.
05-7
8810-05
AIR BAG AND SEAT BELT
REXTON 2006.09