SSANGYONG REXTON 2006.09 Manual page 457

02-6
8511-14
2. FATC SYSTEM BASIC FUNCTION
1) Temperature Control
When you set the setting temperature using the temperature control switch, the FATC receives
the various input signals from sensors including the information of inside air temperature,
ambient temperature, coolant temperature and sun loads etc.. The FATC uses this signals to
control automatically the A/C compressor, the mode door, the Incar/Ambient door, air mix door
and blower motor etc.
1. Ambient Temperature Display
The ambient temperature is displayed using the ambient temperature switch in increment of
0.5°C. When pressing the AMB button, the display shows the ambient temperature and
returns to the adjusted temperature. The ambient temperature switch can be affected by the
heat in the engine compartment since it is installed in front of the radiator. Therefore, the
display can show the correct temperature when the vehicle is driven at over a certain speed
(approx. 40 km/h).
2) Blower Motor Speed Control
For setting at Full AUTO, it is possible to
control the blower motor operation both
manually and automatically in order to adjust
the airflow according to the set temperature.
1. Manual Control
When you push the blower switch, you can
control the blower motor manually and it
increases or decreases each step by
moving the switch to HI/LO.
(with the ignition ON)
FULL AUTO TEMPERTURE CONTROL
REXTON 2006.09