SSANGYONG REXTON 2006.09 Manual page 470

3) Coolant Circulating Route
4) Connecting the Coolant Circuit
The heater is connected to the coolant circuit in the coolant feed pipe from the vehicle engine to
the heat exchanger.
- Parts conveying coolant must be routed and fastened in such a way that they pose no
temperature risk to person or material sensitive to temperature from radiation and direct
contact.
- Before working on the coolant circuit, disconnect the negative battery cable and wait until
all components have cooled down completely.
- When installing the heater and the water pump, note the direction of flow of the coolant
circuit.
- Fill the heater and water hoses with coolant before connecting to the coolant circuit.
- When routing the coolant pipes, observe a sufficient clearance to hot vehicle parts.
- Protect all coolant hoses/coolant pipes from chafing and from extreme temperatures.
- Secure all hose connections with hose clips.
03-9
6910-03
FFH SYSTEM
REXTON 2006.09