Smart Key Verification Fail Warning; Verification Fail Detection And Transmission Conditions; Smart Key Battery Discharge Warning; Transponder Verification Fail Warning - SSANGYONG Korando 2012 Manual

Hide thumbs Also See for Korando 2012:

Table of Contents

(3) Smart key verification fail warning

When the verification is requested for ignition status change or engine starting and no verified smart key

is in the vehicle, the SKM sends the [smart key verification status] signal, which indicates that the

verification has failed, for up to 10 sec. until the verification fail conditions are deactivated.

Normally, the smart key verification warning is one of the smart key fail conditions.

When the ignition status is changed after a smart key is verified by the START switch ON input, the

SKM sends the verification status for 10 sec.

Ignition status change

(OFF ->ACC) / (OFF ->IGN)/(ACC ->IGN) / (IGN -> engine ON)

If above conditions are met again, the SKM re-verifies a smart key and sends the verification status for

another 10 sec.

When the ignition status is changed by the transponder verification while the smart key status is sent

through the BCAN, the SKM sends the smart key verification signal and also sends the transponder

verification signal for 10 sec.

If low smart key battery is detected during the verification process for ignition status change or engine

start, the SKM sends the signal for [smart key battery low voltage warning] to the BCM and instrument

cluster through the BCAN for up to 10 sec. until the warning condition is deactivated.

Smart key battery discharge confirmation and deactivation

If the smart key battery low voltage is confirmed, the SKM sends the smart key battery low voltage

warning signal.

If the smart key battery is in normal condition, the SKM sends the smart key battery low voltage

warning deactivation signal.

The smart key is the last used key.

If a verified smart key is not found by the key verification process, the SKM sends the information that

indicates the key is not verified to the instrument cluster through the BCAN for up to 10 sec. until the

verification fail condition is deactivated.

The SKM sends the transponder verification warning when the verification has failed with the smart key

inserted into the immobilizer holder.

Transponder verification fail detection and transmission conditions

When the ignition status is changed after the transponder is verified by the START switch ON input,

the SKM sends the transponder verification status for 10 sec.