Warning Lamp Condition Change During Operation - SSANGYONG Korando 2012 Manual

Hide thumbs Also See for Korando 2012:

Table of Contents

When there is any active fault or past faults occurred 10 times or more

If there is any active fault or past faults occurred 10 times or more in the last ignition cycle, the SDM

operates the warning lamp as shown below. If below conditions are met, the SDM is operated in the

Active fault

When the past faults occurred 10 times or more (except 'battery voltage too low')

Internal fault

Impact record

Pretensioner deployed only

If the connector is not connected properly or SDM battery voltage is out of the specified range internally

(battery voltage for warning lamp), the warning lamp is kept ON.

Warning lamp condition change during operation

The warning lamp comes on or off according to the actual fault condition during SDM operation. If there is

any active fault or active fault becomes past fault, the warning lamp is illuminated and if the fault is

deactivated, the warning lamp goes off.