SSANGYONG Korando 2012 Manual page 511

3. BASIC INSPECTION
1) Battery Terminal
2) Measuring the Voltage Drop
▶ Measuring at battery terminal
Terminal (+)
Terminal (-)
- Make sure the terminal connections are
securely tightened. If the terminals are
corroded, clean them or replace the battery.
* Cleaning
Remove the corrosion or dirt with a wire brush
or sand paper, and then wash out with
lukewarm soapy water.
- Measure the voltage between battery
terminal (+. -) and wiring clamp.
Specified value
If the terminals are corroded, clean and
retightening them. If the specified tightening
torque cannot be kept, replace the clamp.
Terminal (+): 4 ~ 5 Nm
Terminal (-): 6 ± 1Nm
14-5
0000-00
below 0.3V