Table of Contents
Advertisement
To configure Check-VLAN mode into ARP inspection for specific interface
Example:
To configure Check-VLAN mode (Enabled) into ARP inspection for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # ip arp inspection check-vlan
4.2.56.27 ip arp inspection logging
Command:
ip arp inspection logging all | deny | permit
arp
Address Resolution Protocol
inspection
ARP inspection
logging
ARP inspection logging mode config
all
log all entries
deny
log denied entries
permit
log permitted entries
Default:
None
Usage Guide:
To configure Logging type into ARP inspection for specific interface
Example:
To configure Logging type (All) into ARP inspection for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # ip arp inspection logging all
4.2.56.28 ip arp inspection trust
Command:
ip arp inspection trust
arp
Address Resolution Protocol
inspection
ARP inspection
trust
ARP inspection trust config
Command Guide of MGSW-28240F
-94-
Advertisement
Table of Contents
Need help?
Do you have a question about the MGSW-28240F and is the answer not in the manual?