Table of Contents
Advertisement
Usage Guide:
To configure the timeout of Radius-Server
Example:
To configure the timeout (10) of Radius-Server
Switch# configure terminal
Switch (config)# radius-server timeout 10
4.2.189 rmon alarm
Command:
rmon alarm <id> {<oid_str> | {{ ifInOctets | ifInUcastPkts | ifInNUcastPkts |
ifInDiscards | ifInErrors | ifInUnknownProtos | ifOutOctets | ifOutUcastPkts |
ifOutNUcastPkts | ifOutDiscards | ifOutErrors } <ifIndex>}} <interval: 1-2147483647>
{ absolute | delta } rising-threshold <rising_threshold: -2147483648-2147483647>
[<rising_event_id:
-2147483648-2147483647>
both ] }
rmon
Remote Monitoring
alarm
Configure an RMON alarm
<oid_str>
MIB object to monitor
ifInDiscards
The number of inbound packets that are discarded even
normal
ifInErrors
The number of inbound packets that contained errors
being deliverable to a higher-layer protocol
ifInNUcastPkts
ifInOctets
The total number of octets received on the interface,
characters
ifInUcastPkts
The number of uni-cast packets delivered to a
ifInUnknownProtos
ifOutDiscards
ifOutErrors
The The number of outbound packets that could not be
because of errors
0-65535>]
[ <falling_event_id: 0-65535> ] { [ rising | falling |
The number of broad-cast and multi-cast packets
higher-layer protocol
The number of the inbound packets that were discarded
the unknown or un-support protocol
The number of outbound packets that are discarded
normal
Command Guide of MGSW-28240F
falling-threshold
<falling_threshold:
-287-
the packets are
preventing them from
delivered to a
including framing
higher-layer protocol
because of
event the packets is
transmitted
Advertisement
Table of Contents
