Table of Contents
Advertisement
Powering on the system for the first time requires special preparation and
procedures. For example, if you have not prepared a display before connecting the
AC power cable, system messages could be lost.
Caution – The server goes into Standby mode and the service processor initializes
as soon as the AC power cable is connected to the power source.
●
Go to
"Powering On the System for the First Time" on page 37
on connecting the server to AC power.
Managing Cables With the CMA
Managing the cables with the CMA is the same for both servers.
Securing the Server Cables in the CMA
▼
●
Once the server cables are connected and placed inside the CMA, open the
velcro cable straps and wrap the straps around the CMA securing the cables
inside the CMA. (
Securing the Server Cables With the CMA and Velcro Straps (Either Server)
FIGURE 2-17
).
FIGURE 2-17
Chapter 2 Installing the SPARC Enterprise T5140 and T5240 Servers
for instructions
33
Advertisement
Table of Contents
