Table of Contents
Advertisement
Use this port for server management. This port is needed to set up the service
processor network management port, as detailed in
Network Management Port" on page
Note – Use the service processor serial management port only for server
management. It is the default connection between the service processor and a
terminal or a computer.
Caution – Do not attach a modem to this port.
●
Connect a Category 5 cable from the SER MGT serial management port to the
terminal device.
When connecting either a DB-9 or a DB-25 cable, use an adapter to perform the
crossovers given for each connector.
To Connect the Service Processor Network
▼
Management Port
The service processor network management port is labeled NET MGT (
This port is located just to the right of the serial management (SER MGT) port on the
rear panel.
Service Processor Network Management Port – Rear Panel
FIGURE 2-15
Note – This port is not operational until you configure the network settings
(through the serial management port), as detailed in
Processor Network Management Port" on page
Note – If you have access to a DHCP server on the network, you can see the service
processor get an IP address because the DHCP client is enabled by default.
44.
Chapter 2 Installing the SPARC Enterprise T5140 and T5240 Servers
"Enabling the Service Processor
"To Configure the Service
47.
).
FIGURE 2-15
31
Advertisement
Table of Contents
