Table of Contents
Advertisement
Connecting the Server Cables for Both
Servers
To boot the server, you must connect and configure the network and serial ports. The
procedures are given in the following sections.
"To Connect the Service Processor Serial Management Port" on page 31
■
"To Connect the Service Processor Network Management Port" on page 32
■
"To Connect the Ethernet Network Cables" on page 33
■
"To Connect the AC Power Cable to the Server" on page 34
■
The servers also have serial and USB ports available for connections to optional
devices. See
more information.
Note – When you are finished connecting the cables to the server, ensure that the
server can slide smoothly in and out of the rack without binding or damaging the
cables. See the section,
page
To Connect the Service Processor Serial
▼
Management Port
The service processor serial management port is marked SER MGT (
This port is the farthest left RJ-45 port on the rear panel.
Note – The cable and DB-9 RJ-45 adapters are for the host serial port, and not for
the server SER MGT port.
FIGURE 2-14
30
SPARC Enterprise T5140 and T5240 Servers Installation Guide • February 2008
"Port, Connector, and LED Locations for Both Servers" on page 7
"To Verify the Operation of the Slide Rails and the CMA" on
29.
Service Processor Serial Management Port – Rear Panel
for
).
FIGURE 2-14
Advertisement
Table of Contents
