Table of Contents
Advertisement
Installing the Cable Management Arm
The rackmounting kit for each server comes with the same cable management arm
(CMA) assembly. The CMA installation procedures are the same for both servers. See
"Installing the Cable Management Arm for Both Servers" on page
24.
Connecting the Server Cables
To boot the server, you must connect and configure the network and serial ports. For
instructions, see
"Connecting the Server Cables for Both Servers" on page
31.
Managing Cables With the CMA
Managing the cables with the CMA is the same for both servers. See
"Managing
Cables With the CMA" on page
34.
Dismounting the Server
Caution – To prevent damage to your server, do not move the rack while the server
is mounted.
To install or replace internal parts in the server, you must first remove the server
from the rack. For the removal procedure, refer to the SPARC Enterprise T5140 and
T5240 Servers Service Manual.
Appendix C
Installing the Servers With the Express Rail Rackmounting Kit
79
Advertisement
Table of Contents
