Protocols; E.5.3 Protocols - TESTO 340 Instruction Manual

24
The parameters
and
Dew p./amb.
and DP (Flue gas dew point temperature). The parameters should be set to the factory
settings for all standard applications (Temp./amb.: 20.0 °C, Hum/amb.: 80.0 %, Dew p./
amb.: 16.4 °C). To achieve greater accuracy, the values can be adjusted to the actual
ambient conditions.
If the ambient air temperature sensor is plugged in, the value for Temp./amb. is accep-
ted automatically. The parameter
and
amb. Hum/amb.
1 Select the folder Ý
2 Select the location Ý
Options:
To set the shape of the cross-section:
Cross section
To set the surface area of the cross-section:
Cross section
OK .
To set parameters:
Select the parameter Ý
3
OK To location

E.5.3 Protocols

Printing/deleting all protocols :
Select the folder Ý
- The saved protocols are displayed. Protocols of measurement programs are marked
with a vertical line and the number of individual measurements (e.g.
than 999 measurements dots are used (
a measurement protocol the following symbol is displayed next to the protocol name:
. The data are printed with the protocol printout.
Options:
To print all data: Print all Ý
To delete all data: Delete all Ý
(ambient air temperature),
Temp./amb.
(ambient air dew point) influence calculation of the qA (Flue gas loss)
Dew p./amb.
via the function key
.
OK
Edit .
Ý Select the cross-section Ý
Change
Ý
Change Ý Select the cross-section Ý
Ý
Change
OK .
Ý
Ý Select a location Ý
OK
can be calculated from the values of
calc .
Ý Set the values Ý
). If automatic furnace data are stored with
|...
OK .
OK .
(ambient air humidity)
Hum/amb.
4 .
Change Ý Set the values Ý
.
OK
.
Data
Temp./
), for more
|245