Technical characteristics
Net weight
Gross weight
Electrical
Nominal
Frequency
Amperage (Idle)
Operation
9)
Water protection
1) These flow rates are based upon setting the unit to higher temperatures and then mixing down using cold water after the unit.
2) Input rating is based on sea level operation and need not be changed for operation up to 2000 ft (610 m) elevation. For
operation at elevations above 2000 ft (610 m), input rating is automatically reduced at the rate of 4 percent for each 1000 ft
(305 m) above sea level.
3) When converted to LPG the minimum input is 17 000 BTU/hr (5 kW).
4) with constant flow
5) Can be reprogrammed to achieve 140 °F (60 °C) (see chapter 6.4).
6) Requirements: Steady flows, single unit installations, up to 140 °F (60 °C).
7) To measure Gas Pressure, see Measuring Gas Pressure, chapter 4.13, page 43.
8) Refers to activation point. Deactivation point value is 0.35GPM (1.3 l/min).
9) Protection against water splashing.
Table 3
Safety devices
•
Flame failure device (flame detection via ionization rod)
•
Overheat prevention
•
Inlet water temperature sensor
•
Outlet water temperature sensor
•
Exhaust flue gas temperature sensor
•
Water flow sensor
•
Air flow sensing technology (Optiflow)
•
Scaling detection sensor (HE flue gas temperature sensor)
Greentherm T9900 SE/i – 6 720 813 635 (2019/03)
Units
Greentherm T9900 SE/i
199 000 Btu
pounds (kg)
78.70 (35.7) / 81.13 (36.8)
pounds (kg)
91.05 (41.3) / 93.48 (42.4)
V AC
Hz
mA
A
IP
Greentherm T9900 SE
120
60
40
≤ 2,7
X4D
Appliance details
160 000 Btu
74.3 (33.7)
86.64 (39.3)
120
60
40
≤ 2,7
X4D
11
Need help?
Do you have a question about the Greentherm T9900 SE 160 and is the answer not in the manual?