Replaceable End Points Of Rear Pto Shaft; Facilitating Connection Of Joint Shaft Of An Aggregated Machine To The Tractor - Zetor Proxima GP Series Operator's Manual

Rear output shaft - shifting of speed of the output shaft 540 and 1,000 or 540E rpm
Shifting is performed by the lever (1) when the tractor is in
standstill.
The tractor is equipped standardly with a combination of
540 and 1,000 rpm of the output shaft; other optional
combination is 540 and 540E rpm of the output shaft.
-1
a -
1,000 min or 540E min
-1
b -
540 min
Shifting of 540 and 1,000 (or 540E) min
possible regardless to the number of splines of the
installed terminal. Speed of the output shaft and type
of terminal shall be chosen depending on the
prescribed rpm of the coupled mechanism.

Replaceable end points of rear PTO shaft

The tractor is equipped with six or twenty-one splined
replaceable end point of rear PTO shaft.
Replacement procedure:
1. Use safety ring pliers to demount a safety ring (1)
2. Remove replaceable end point by pulling in the
direction of an arrow (2)
3. Mount the end point in an opposite way, pay increased
attention to the mounting of the safety ring (1)
Replacement of the terminal shall be performed
when the engine is stopped.
Rpm of the output shaft and terminal type shall be
chosen depending on the prescribed rpm of the
coupled mechanism.
Shifting 540 and 1,000 or 540E min
regardless to the number of splines of the installed
terminal.

Facilitating connection of joint shaft of an aggregated machine to the tractor

For facilitating the connection of joint shaft of aggregated machine to a tractor a button (1) placed on
mudguards can be used.
With the engine running and rear PTO shaft switch off, spinning of rear PTO shaft occurs after pressing the
button (1). PTO shaft stops spinning after releasing the button.
Beware: Rear PTO shaft revolutions preselection lever must not be in (N) position or in the position of
a dependent revolution of rear PTO shaft.
When manipulating with PTO shaft by means of buttons (1), the operator must stand beyond
the space of the connected tools not to be caught or injured.
DRIVE OF FARMING MACHINES
-1
-1
is
-1
is possible
FH12N002
68
G153
E357