Replaceable Ends Of Rear Pto Shaft; Maximum Transmitted Output - Zetor PROXIMA PLUS 8541 Operator's Manual

REPLACEABLE ENDS OF REAR PTO
SHAFT
Standard the tractor is equipped with the
fixed 6-spline end.
∗ On customer's wish the tractor may be
equipped with 6- or 21-spline replace-
able end of the PTO shaft.
Replacement procedure:
1. Use circlip pliers to remove the
circlip (1).
2. Pull the replaceable end in the arrow
direction (2) to remove it.
3. Installation is a reverse procedure to
removal, pay special care to installa-
tion of the circlip (1).
PTO DRIVE OF AGRICULTURAL MACHINES
E357
Replacement of the shaft end
must be done with the stopped
engine.
Select the PTO shaft speed and
end type according to the imple-
ment prescribed speed.
Shifting of 540 and 1000 or 540E
rpm is possible regardless of the
number of splines of the installed
shaft end.

MAXIMUM TRANSMITTED OUTPUT

front
rear
* If it applies to the transmitted output
without shocks, the value of the maxi-
mum transmitted output may be in-
creased to 50 kW.
88
Transmitted
PTO shaft
output
1,000 rpm 45 kW*
1,000 rpm full engine output
540 rpm full engine output
540E rpm full engine output
E358