Master-Slave Configuration - Crestron 3 Series Reference Manual

Master-Slave Configuration

Use the following console commands to configure master-slave mode
parameters for the control system.
Add Master Entry
To add a master entry to the IP table, use the ADDMASTER command.
•
•
Remove Master Entry
To remove a master entry from the IP table, use the REMMASTER command.
•
•
View Master IP Table
To view the master IP table, use the MIPTABLE command. Append [-T] to the
command to output the results in table format.
View Slave Status
To display the status of the slave processor, use the SLAVESTATUS command.
Reference Guide – DOC. 7150B
Syntax: ADDMASTER [cipid] -[ip_address/name]
cipid: The ID of the CIP node (in hexadecimal format)
o
ip_address/name: The IP address (in dot decimal notation) or the
o
name of the site for DNS lookup
Example: ADDMASTER 1E -PRO3-IH
Syntax: REMMASTER [cipid] -[ip_address/name]
cipid: The ID of the CIP node (in hexadecimal format)
o
ip_address/name: The IP address (in dot decimal notation) or the
o
name of the site for DNS lookup
Example: REMMASTER 1E -PRO3-IH
3-Series Control Systems • 43