Crestron 3 Series Reference Manual page 43

Remove Peer Entry
To remove a peer (slave) entry from the IP table, use the REMPEER command.
•
•
Load IP Table
To load a program-specific DIP file from removable media to the "\Sys\"
directory of the control system, issue the LOADIPTABLE command.
•
•
NOTE:
Reference Guide – DOC. 7150B
Syntax: REMPEER cipid ip_address/name [-D:device_id] [-
C:cipport] [-P:program][-U:RoomId]
cipid: The ID of the CIP node (in hexadecimal format)
o
ip_address/name: The IP address (in dot decimal notation) or the
o
name of the site for DNS lookup
-D:device_id: The device ID in the device redirection table (in hex,
o
must be less than 256)
-C:cipport: The CIP port number for the connection (must be
o
greater than 256)
-P:program: The program number on the control system that uses
o
the device (default is 1)
-U:RoomId: The room ID used for communication with a Crestron
o
Virutal Control server (max length is 32 characters, valid values are A-
Z and 0-9)
Example: REMPEER 13 255.255.255.255 -D:134 -C:458 -P:3
-U:AVF469
Syntax: LOADIPTABLE -p:[AppId] [path]
-p:[AppId]: The specific program identifier
o
path: The path of the file on removable media, including "\" (such as
o
"\RM\TmpDir" or "\RM2\dipDir"
Example: LOADIPTABLE -p:1 \RM\dipDir
The program must be restarted for the new IP table to take effect.
3-Series Control Systems • 39