Service Error Codes - Ricoh LI-MF1 M126 Field Service Manual

Error
Scanner jam, remove all originals from the
scanner. This message appears if the ADF
292
cover is open while paper is fed through the
ADF.
Flatbed cover open. The machine senses that
293.02
the flatbed cover is open.
Scanner jam, remove all originals from the
294.04
scanner. Jam at the ADF exit sensor.
Scanner jam, remove all originals from the
294.05 scanner. A jam is detected at the ADF exit
sensor.
ADF Backfeed Jam. A jam is detected at the
294.06
ADF exit sensor.
295.01 Scanner Disable Page at CCD
295.02 Scanner Disable Page at CCD

Service Error Codes

Service error codes are generally non-recoverable except in an intermittent condition when the machine
can be put into POR to temporarily recover from the error condition.
Error
8XX Scanner service errors
840.01
The scanner is disabled and can't be
Scanner
used.
disabled
Description
Description
Messages and Error Codes
Action
Remove the paper from the ADF, and
close the ADF cover. If the error recurs,
go to "ADF Cover Open Service Check"
in "Troubleshooting".
Close the flatbed cover (
Cover Open Service Check").
294.06Remove all paper from the ADF.
If the error recurs, go to "ADF Paper Jam
Service Check" in "Troubleshooting".
ADF page gap is too small. Not enough
to re initialize the image processing unit.
Remove paper from the ADF.
The ADF page gap is too small, not
enough room to accelerate after pausing.
Remove paper from the ADF.
Action
Enter the configuration menu, and re-enable
the scanner module( p.265 "840.xx
Service Check").
p.269 "ADF
6
219