4. Replacement and Adjustment
4
2. Remove the three screws (A) from the right rear frame assembly.
3. Carefully lift the right rear frame assembly off the print engine frame.
Tub Assembly Removal
1. Flatbed assembly (
2. Disconnect the remaining cables from the controller board.
3. Thread the cables through the tub assembly and top cover.
4. Controller board cage (
5. Operator panel keyboard (
6. Operator panel display (
7. Left rear frame assembly (
98
p.111 "Flatbed Removal")
p.50 "Controller Board Cage")
p.90 "Operator Panel Keypad Removal")
p.91 "Operator Panel Display Removal")
p.96 "Left Rear Frame Assembly Removal")