Table of Contents
Advertisement
Demonstration architecture overview
d)
Figure 16. Connection status screen
3.
In point-to-point configuration, connect your PC to the STM3220G-EVAL board using
an Ethernet cross cable.
4.
In a local network, connect the STM3220G-EVAL board to the network hub using an
Ethernet regular cable.
5.
Ping the board by typing in the DOS command window: "ping xx.xx.xx.xx" where
xx.xx.xx.xx is the DHCP or the statically assigned IP address.
6.
In your internet browser, type "http:// xx.xx.xx.xx" to load the STM32 web page.
7.
Now you can turn on/off the four LEDs on the STM3220G-EVAL board.
14/21
If the DHCP is supported, enable the DHCP and the STM3220G-EVAL board will
automatically acquire an IP address.
Doc ID 018665 Rev 3
UM1069
Advertisement
Table of Contents
Need help?
Do you have a question about the STM3220G-EVAL and is the answer not in the manual?
Questions and answers