Programming The Demonstration - ST STM3220G-EVAL User Manual

UM1069
3

Programming the demonstration

Normally, the STM3220G-EVAL demo is included with the board and the necessary
accessories described in
program the board by using the binary file included with the demo package (in the \Binary
folder).
Note: Demonstration binary files are provided also for the legacy STM3220F-EVAL board Rev. A.
"_vx_y_z" in the file name refers to the version of the demonstration firmware.
You can program the demonstration using either the EWARM or the Bootloader method.
Using the EWARM (v6.10 and later) preconfigured project
1. Open the EWARM\Flash_Loader.ewd workspace.
Open Project > Download > Download file, and select the *.out file to program:
2.
–
–
3. Once the binary is programmed, remove the JTAG probe and restart the board.
Using the Bootloader
Depending on the Bootloader serial interface you are using, you have to proceed as follows:
1. For USART or CAN interfaces:
a)
b)
2. For USB FS Device mode (DFU) interface:
a)
b)
3. Once the binary is programmed, configure the boot pins to the "Boot from Flash"
position and restart the board.
For more information about the STM32F2xx Bootloader, please refer to AN2606, STM32
microcontroller system memory boot mode.
Section 1.2.1: Required
Load the Binary\STM3220G-EVAL_FW_vx_y_z.out file for the STM3220G-EVAL
Rev. B
Load the Binary\STM3220F-EVAL_FW_vx_y_z.out file for the STM3220F-EVAL
Rev. A
Load the Binary\STM3220G-EVAL_FW_vx_y_z.bin file for the STM3220G-EVAL
Rev. B
Load the Binary\STM3220F-EVAL_FW_vx_y_z.bin file for the STM3220F-EVAL
Rev. A
Load the Binary\STM3220G-EVAL_FW_vx_y_z.dfu file for the STM3220G-EVAL
Rev. B
Load the Binary\STM3220F-EVAL_FW_vx_y_z.dfu file for the STM3220F-EVAL
Rev. A
Doc ID 018665 Rev 3
Programming the demonstration
accessories. However, the user can
19/21