Advertisement
Available languages
Available languages
Unit indication LEDs (LED panel dedicated)
Indicates the unit of the parameter value shown on the display.
Hz･A･%
Minus polarity indication LED (LED panel dedicated)
Lights when the number on the display is a minus number.
——
Operation keys
Starts the drive in the forward direction. (in Local Mode only)
Starts the drive in the reverse direction. (in Local Mode only)
Stops the drive. The motor will either coast to a stop or ramp down to a stop as
selected on C00-1.
When this key is held down for two seconds or longer during operation, the motor
will coast to stop regardless of Local Mode or Remote Mode.
Held down for 2
sec.
Changes control Modes from Local to Remote, or vice-versa. When the drive is in
Local Mode, "LCL" LED is on.
The drive is default set so that a Local/Remote selection is disabled while the drive is
STOP
LCL
＋
running. Even while the drive is at a stop, this selection cannot be made if operating
SET
commands such as RUN, JOG, etc., are being received at the terminal. This lock can
be released with Parameter C09-2.
Resets a fault, putting out FLT LED.
STOP
RS
＋
MO
Parameter operation keys ･ Parameter operation knob
Changes the block No. mode displayed on the indicator in the following order each
time the key is pressed:
RST
MOD
Monitor → Parameter A → Parameter B → Parameter C → Utility Mode U.
Fixes Parameter number or set its values.
LCL
SET
Param. Select
Valve change
Parameter increase/decrease key, parameter increase/decrease knob
or
or
＋
or
＋
or
Operations dedicated for LED panel
Held down
Held down
When main & sub-No. selection method (C11-7=2) is selected for
parameter setting method, moves from sub-No. selection to main
No. selection.
Moves the digit to increment or decrement.
Increases the parameter No. or parameter setting value.
Decreases the parameter No. or parameter setting value.
When the parameter is being set with the sub-No. selection method
(C11-7=1), increases the parameter's main No.
When the parameter is being set with the sub-No. selection method
(C11-7=1), decreases the parameter's main No.
Increases the parameter No. or setting value at a fast speed.
Decreases the parameter No. or setting value at a fast speed.
EN-17
Advertisement
