Basic System Configurations; Using This Manual - Eaton Powerware 9315 Installation And Operation Manual

Basic System Configurations

These basic Parallel Capacity/Redundant system configurations are possible:
•
System Bypass Module (SBM) with optional System Maintenance Bypass (SMB),
two or more UPS modules, and one battery rack for each module
•
System Bypass Module (SBM) with optional System Maintenance Bypass (SMB),
two or more UPS modules, and one common battery rack
•
System Bypass Module (SBM) with optional System Maintenance Bypass SMB),
two or more UPS modules, one battery rack for each module, and an input
transformer
•
System Bypass Module (SBM) with optional System Maintenance Bypass (SMB),
two or more UPS modules, one common battery rack, and an input transformer
You can enhance any of these system configurations by adding optional accessories,
such as a Remote Monitor Panel (RMP), Relay Interface Module (RIM), Supervisory
Contact Module (SCM), or Remote Emergency Power Off (EPO) control.

Using This Manual

The information in this manual is divided into the sections and chapters listed.
The system you are installing dictates which parts of this manual you should read.
Everyone should read the Introduction, Chapters 1 and 2 and Chapters 7 through
12.
Introduction
The Introduction provides a brief description of the Parallel Capacity/Redundant
system, a description of the content of each chapter, safety, text conventions
used in the manual and reference information.
Section I
•
Chapter 1 − Getting Started − tells you how to prepare your site for the
installation of your Parallel Capacity/Redundant system. It discusses
equipment environmental requirements, inspecting, and unpacking cabinets.
•
Chapter 2 − Installing the Parallel Capacity/Redundant System − describes
how to install the SBM cabinet and provides references for installing UPMs and
optional equipment.
•
Chapter 3 − Installing a Remote EPO Control − contains information for
installing the optional Remote Emergency Power Off (EPO) control.
•
Chapter 4 − Installing a Remote Monitor Panel − contains information for
installing the optional Remote Monitor Panel (RMP).
•
Chapter 5 − Installing a Relay Interface Module − contains information for
installing the optional Relay Interface Panel (RIM).
•
Chapter 6 − Installing a Supervisory Contact Module − contains information
for installing the optional Supervisory Contact Module (SCM).
EATON Powerware 9315 Parallel Capacity/Redundant System
164201150 Rev. E www.powerware.com
iii