Figure 9−11. Port Setup Screen - Eaton Powerware 9315 Installation And Operation Manual

Select Port 1 or Port 2 from the Setup menu to display one of the Port Setup
screens. The Port Setup screens allow you to specify settings for the two serial
communication ports on the UPS. Figure 9−11 shows the Setup Serial Port 1
screen.
UPS System Normal
Alarm: None
Notice: None
Battery
Minutes
48.5
Setup
Port 1
Port 2
Time
Language
Meters Events
The small return arrow (
screen. This arrow is a reminder that you can press the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons
to change the port configuration. To change a setting, press the
to move the highlight to the setting you want to change. To scroll through the
available options for that setting, press the
settings upon exit from this screen, be sure the SAVE field is set to YES.
The setup screens for Port 1 and Port 2 are identical. For detailed information
about configuring the serial ports, refer to Chapter 13, Serial Communications."
EATON Powerware 9315 Parallel Capacity/Redundant System
164201150 Rev. E www.powerware.com
Uninterruptible Power System
MODE
TERMINAL
Statistics Graphics Setup
Figure 9−11. Port Setup Screen
) appears in the upper right corner of the Port Setup
15 NOV 1997
Setup Serial Port 1
RATE DATA/STOP HANDSHAKING
9600 8 1 XON / XOFF
or pushbutton. To save the
09:25:45
SAVE
NO
pushbutton on the
and pushbuttons
9−13