Table of Contents
Advertisement
4
CLEANING AND MAINTENANCE
GENERAL ADVICE
Before you begin cleaning, you
•
must ensure that the appliance is
switched off and disconnected from
the electrical power supply.
Important: The use of suitable
•
protective
recommended when handling or
cleaning of this appliance.
•
Under no circumstances should
any external covers be removed for
servicing or maintenance except by
suitable qualified personnel.
•
It is advisable to clean when the
appliance is cold and especially for
cleaning the enamelled parts.
Be
very
careful
•
penetrates inside the appliance.
•
Avoid
leaving
substances (lemon juice, vinegar, etc.)
on the surfaces.
•
Avoid using cleaning products with a
chlorine or acidic base.
The oven must always be cleaned after
•
every use, using suitable products.
WARNING
When correctly installed, your product
meets all safety requirements laid
down for this type of product category.
However special care should be taken
around the rear or the underneath of
the appliance as these areas are not
designed or intended to be touched and
may contain sharp or rough edges, that
may cause injury.
Important: The manufacturer declines all liability for possible damage caused by
the use of unsuitable products to clean the appliance.
Do not use a steam cleaner because the moisture can get into the appliance thus
make it unsafe.
Do not store flammable material in the oven.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door
glass since they can scratch the surface, which may result in shattering of the glass.
20
clothing/gloves
that
no
water
alkaline
or
acidic
GLASS CONTROL PANEL
Clean using an appropriate product. Always
dry thoroughly.
Do not use harsh abrasive cleaners or
sharp metal scrapers to clean the control
panel since they can scratch the surface,
is
which may result in shattering of the glass.
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a microfibre or soft
cloth.
Acidic substances like lemon juice, tomato
sauce, vinegar etc. can damage the enamel
if left too long.
STAINLESS
PARTS,
SCREEN PRINTED SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be cleaned
very carefully to avoid scratching and
abrasion. You are advised to use a soft
cloth and neutral soap.
CAUTION:
substances or non-neutral detergents
as these will irreparably damage the
surface.
STEEL,
ALUMINIUM
PAINTED
AND
Do
not
use
SILK-
abrasive
Advertisement
Table of Contents
