Table of Contents
Advertisement
FIXING THE OVEN
Introduce the oven into the furniture opening and fix it with 4 screws (not supplied) as figure
5.2. It is essential that the oven rests on a surface which will support its weight, as the
screw fixing is only complementary.
Adjust the hinges of furniture doors adjacent to the oven to allow a 4-5 mm gap between
the furniture door and the oven frame.
Fig. 5.2
IMPORTANT:
To avoid damage to the lower trim please note the following instructions.
The lower trim is designed to allow for good air circulation and the correct opening of the
oven door.
To ensure the trim is not damaged due to the appliance being placed on the floor, the
appliance should be suitably supported as in illustration here below.
After installation the appliance door should be slowly opened to ensure no damage has
occurred.
No responsibility for lower trim damage will be accepted if these instructions have
not been followed.
Oven
door
Lower
trim
Fig. 5.3
Air flow
33
Advertisement
Table of Contents
