Connection Of The Power Supply Cable - Elba EBO 9910 S Instructions For The Use

CONNECTION OF THE POWER SUPPLY CABLE

WARNING: If the power supply cable is damaged, it must be replaced only by an
authorised service agent in order to avoid a hazard.
Unhook the terminal board cover by inserting a screwdriver into the two hooks "A" (fig.
•
6.1).
Unscrew the screw "D" and open completely the cable clamp "E" (fig. 6.2).
•
• Connect the phase, neutral and earth wires to terminal board "G" according to the
diagram in fig. 6.3.
Strain the feeder cable and block it with cable clamp "E" (by screwing screw "D").
•
Close the terminal block cover (check the two hooks "A" are correctly hooked).
•
IMPORTANT: To connect the power supply cable DO NOT unscrew the screws fixing
the cover plate behind the terminal block.
NOTE: The earth conductor must be left about 3 cm longer than the others.
FEEDER CABLE SECTION
Type "H05RR-F"
220-240 Vac
(*) Connection possible with plug and outlet
(**) Connection with wall box connection.
Fig. 6.1
3 x 1,5 mm
2
(*) (**)
A
1
L1
3
N
L2
5
PE
D
220-240 V ac
G
2
4
E
Fig. 6.2
L
N
PE
Fig. 6.3
35