Operating, Transport And Storage Conditions - Dentsply Sirona Intego Installation Manual

Dentsply Sirona
Installation requirements Intego
+70 95
1060
-40 10 500
+40 85
1060
+10
30 700
64 57 092 D3543
D3543.021.01.09.02 12.2018
4.6.1

Operating, transport and storage conditions

Mode of operation
Transport and storage con-
ditions:
Operating conditions:
Installation location:
Pollution degree:
Load capacity of the patient
chair:
Local pressure (min./max):
For details see page Re-
quirements of the supply
media [→ 12]
Water flow:
For details see page Re-
quirements of the supply
media [→ 12]
4 Dimensions, technical data
4.6 Technical data
Continuous operation with intermittent
loading corresponding to the dental
mode of working.
Drive motors for chair operation:
intermittent use, max. 2 minutes on and
18 minutes off
Permanently connected unit. Operation
is not permitted in mobile vehicles.
Temperature: -40°C – +70°C
(-40°F – 158°F)
Relative humidity: 10% – 95%
Air pressure: 500 hPa – 1060 hPa
Ambient temperature: 10°C – 40°C
(50°F – 104°F)
Relative humidity: 30% – 85%
without condensation
Air pressure: 700 hPa – 1060 hPa
≤ 3000 m above sea level
This treatment center is not suitable for
operation in areas subject to explosion
hazards.
2 acc. to IEC 60664-1
140 kg (308.6 lbs) or 185 kg
(407.9 lbs), depending on the model
The max. load capacity is indicated on
a sticker next to the rating plate of the
treatment center.
Air: 5.5 / 7.5 bar
Water 2.5 / 6 bar
Suction air: p min. 0.12 bar (1.7 psi),
u
max. 0.18 bar (2.6 psi)
≥ 500 l/min
Water absorption max. 3 l/min
Residual water max. 3 l/min
59