Communication Tab - Pepperl+Fuchs ODT-MAC400 Series Manual

ODT-MAC400-* / ODT-MAC401-* / ODT-MAC403-*
Operation
7.1.2

Communication Tab

The Communication tab allows you to configure various network and
transmission parameters. In the left display area, you can navigate to the other
tabs Settings, Gallery and Language.
In the center of the screen, the following functions are available in different fields:
Parameters
IP address
Subnet mask
Gateway
TCP/IP port for process
communication
Output signal length
Trigger delay [ms]
Baud rate
Serial port
Transferring parameters
1. Carry out the desired settings.
2. Transfer the settings by clicking OK .
50
Explanation
Assign a new IP address to the sensor using this field.
Change the subnet mask using this field.
Change the gateway using this field.
Change the TCP/IP port using this field. The output strings
are sent to the remote station (e.g., PLC) via this port. After
making the changes, you must press OK to confirm your
entries and reboot the system.
Change the temporal length of the output signal using this
field.
Change the trigger delay using this field. Value range: 1 ms ...
255 ms
Change the baud rate using this field.
Activate or deactivate the RS232 interface output.