ODT-MAC400-* / ODT-MAC401-* / ODT-MAC403-*
Operation
7.1.1
Settings Tab
The Settings tab enables you to configure various parameters and send
commands to the sensor. In the left display area, you can navigate to the other
tabs Communication, Gallery and Language.
In the center of the screen, the following functions are available in different fields:
Sensor parameters
Settings
Flash duration
Gain
Parameter set
Command
Reset counter
20
Explanation
This parameter is used to set the duration of the flash at
intervals of 10 µs.
This parameter is used to set the electronic brightness gain. A
high value electronically increases the brightness of the
captured image and can improve the readability of the code
considerably in the event of poor ambient conditions.
Load from Flash: Use this button to load parameter settings
from the internal memory (Flash EEPROM).
Save to Flash: Use this button to save your current parameter
settings in the internal memory (Flash EEPROM).
Send individual commands to the sensor.
The trigger counter value can be reset to 0 here.