Set Up; Uncrating And Installation - Dake TB16 Instructional Manual

handle are clamped tight to the column, and head and table support collars are correctly
positioned.
• Before switching the power on be sure the belt cover is down, and the bit is installed
properly in the chuck.
• Lockout the motor switch when leaving the drill press. Don't perform layout, assembly, or
setup work on the table while the cutting tools rotating.
Voltage Warning:
• Before connecting the machine to a power source know your incoming voltage.
• At power source with voltage greater than that specified for the machine can result in
serious injury to the user and can damage the machine.
• Using a power source with voltage less than that of the machines rating can damage the
motor and other components.
• If you are unsure of the voltage rating do not use the machine.

SET UP

UNCRATING AND INSTALLATION

1. Location of the drill press should be in a well-lit area with correct power supply and that
will not interfere with other machines or operations.
2. Carefully uncrate machine and inspect all packing to make sure no parts are manuals
are thrown out.
3. When transporting the machine please use caution. If using a sling have someone
steady the machine while moving.
4. Install your drill press on a sturdy level floor surface, or workbench. The machine must
be anchored to the floor or workbench securely, the machine is top heavy.
5. Connect appropriate power to the machine. Make sure circuit breakers are suitable for
the machine. Consult local codes for proper installation of machine. Always route power
cables in a safe manner away from traffic areas, damp areas, heat, and moving parts.
6. After installing the drill press, use the kerosene or degreasing product to clean off the
anti-rust oil which was applied at the factory. Then wipe machined surfaces with a light
coating of lubricant oil (way oil).
7. Check for damaged parts before further use of the machine. A guard or other part that is
damaged should be replaced or repaired before use. Carefully check to determine that it
will operate properly and perform its intended function. Check for alignment of moving
parts and binding od moving parts. Breakage of parts or mountings and or any other
conditions that could be affect its operation.
8
Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
REV012019