Table of Contents
Advertisement
GROUNDING INSTRUCTIONS
In the event of a malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk or electrical shock. This machine is equipped with an electric
cord must be used with a matching outlet that is properly installed and grounded in accordance
with all local codes and ordinances.
• Do not modify the plug provided. If it will not fit the outlet have the proper outlet installed
by a qualified electrician.
• Improper connection of the equipment grounding can result in a risk of electrical shock.
The conductor with insulation having an outer surface that is green with yellow stripes is
equipment grounding conductor. If repair or replacement of the electric cord or plug is
necessary, do not connect the equipment grounding conductor to a live terminal.
• Check with a qualified electrician or serviceman if the grounding instructions are not
completely understood, or if in doubt as whether the machine is properly grounded.
• It is not recommended to use an extension cord on the machine. If one must be used,
use only a grounded cord on the machine and length of run needed.
• Repaired or replace damaged or worn cords immediately.
OPERATION
DRILL/CHUCK INSTALLATION
1. Before inserting drill bits, chucks, or arbors always clean out the spindle hole and taper
hole with a clean cloth.
2. Open chuck jaws completely by turning attached chuck key counter-clockwise until the
jaws are fully opened.
3. To install the chuck to the arbor tightly, slide the chuck into the taper forcing it into the
spindle with by handle.
4. Place a block of wood on the table then lower the spindle to contact the wood and press
the chuck tightly into the spindle taper.
5. Install a taper shaft drill into the taper the same way as you would the chuck. If an
adaptor is used it must fit the taper correctly and the bit must fit snug in the adaptor.
9
Dake Corporation
724 Robbins Road
Grand Haven, MI 49417
www.dakecorp.com
REV012019
Advertisement
Table of Contents
