Day Of The Week (Dn, N = 1 To 7) - Pentair FLECK 5810 SXT Installer Manual

Installer Manual Fleck 5810 - SXT - Programming
6.5.13.3 For regeneration type O-UF and O-DF
Note
The regeneration cycles are identified as C1 to C20.
Mandatory
The last cycle must be set with LC.
AE Press or
AF Press to validate the selection.
AG Press or
AH Press to validate the selection and move to the next regeneration
cycle.
AI Repeat AE to AH as needed.
AJ Select LC.
AK Press to validate the selection and to move to the next parameter.

6.5.14. Day of the week (Dn, n = 1 to 7)

Set the active days for regeneration.
Note
The day of week parameter is only available if day of the week mode has been set in
regeneration control type selection.
Note
The current day is defined from D1 (Monday) to D7 (Sunday).
Note
By default, every Dn is set to OFF.
AL Press or
AM Press to validate the selection.
AN Repeat AL to AM until D7 is set.
AO Press to validate the selection and move to the next parameter.
66 / 106
to set the type of regeneration cycle.
to set the duration of this cycle.
to set "ON" or "OFF" to set the day as a regeneration day.
In this example: 
C1 = Rapid Rinse
for 30 min
Ref. MKT-IM-016 / C - 08.06.2018