Entering Master Programming Mode; Display Format Mode (Df) - Pentair FLECK 5810 SXT Installer Manual

Parameter
ET Relay end time
Flow based relay
VR
setting
VO Volume interval
TO Relay time ON

6.5.2. Entering master programming mode

A Press and hold
icon and the parameter display reads TD.
B Set the time to 12:01 PM with
C Press to validate the selection and return to the service mode, or wait
for 10 seconds.
D Press and hold
service icon and the display format screen appears.

6.5.3. Display format mode (DF)

Select the unit of measure.
Options:
• GAL: U.S. Gallons and 12-Hour AM/PM;
• Ltr: litres and 24-Hour.
E Press or
F Press to validate the selection and move to the next parameter.
Ref. MKT-IM-016 / C - 08.06.2018
Options
Relay start
time +1 to
regeneration
duration
OFF - Fb
1 to the total
capacity
1 to 7200
or until the programming icon replaces the service
or
and until the programming icon replaces the
to select the unit.
Installer Manual Fleck 5810 - SXT - Programming
Definition
Minute Only displayed for tb relay setting.
Only displayed if time based relay (RE)
Flow based
is set to OFF.
Litre
Only displayed for Fb relay setting.
Minute
.
Note
59 / 106